The short answerOnly when water movement is included in the design. Finished elevations, slope, surrounding ground, roof runoff, and a lawful drainage outlet must work together. Replacing a surface without addressing the source can leave ponding unchanged or move water toward a building or neighboring property.
Find where the water comes from
Observe the area during rain if it is safe. Note downspout locations, overflowing gutters, high adjacent ground, low door thresholds, and where the puddle first forms. A low spot in the concrete may be obvious, but the water supplying it can originate well beyond the slab.
The new surface must also fit fixed elevations such as garage floors, steps, sidewalks, fences, and property lines. There may not be enough room to create the desired slope in the preferred direction. Those constraints should be discussed before demolition establishes the new layout.
A drain is only useful with an outlet
Channel drains, catch basins, swales, and grading changes collect or redirect water; they do not make it disappear. Any piping needs a suitable destination, protection from blockage where needed, and compliance with local stormwater rules. Discharging onto a neighbor or into an unapproved sewer connection is not a solution.
Ask the proposal to distinguish concrete slope from separate drainage work. It should identify what is included, where water is intended to go, and which surrounding areas remain unchanged. No contractor can responsibly diagnose the entire drainage pattern from one dry-weather photograph.
Before you approve the work
- Photograph ponding and mark its deepest area.
- Record downspouts and nearby low elevations.
- Ask where redirected water will discharge.
- Confirm local drainage and stormwater requirements.